Flex Grid Angle

Installation Instructions

Flex Grid Angle is designed as a trim angle and is not designed to support the grid. Fasten it to the wall as you would any grid angle. To prevent the soft PVC part from deflecting downward, cut cross T’s as long as possible to rest on the rigid part of the coextrusion. See detail. It will finish columns with a 5 1/2“ radius or larger.

To use on an inside radius, fasten to the wall, and allow 24 hours for the part to relax into place. Any ripples can be removed with a heat gun. Use a slow motion along the rippled edge. Instead of overheating an area, it may be easier to make a couple of passes allowing the part to cool between passes. The minimum inside radius is 60“, which is a 10’ diameter.